Dimension Needed
Posted: 2011 Feb 07 Mon 10:21 pm
You cunning linguists give me a chuckle.
I am looking for some help on a dimesion for the lower tailgate on my Connie. What I need is a measurement on the lower tailgate rubber seal channel that is part of the rear floor pan. Top part of this channel has a rad in it and the bottom is flat. I need to replace the flat lower lip and I need to know how far it stands out. Does it come flush with the body or is it below that height?
Mine has been attacked by very severe rust and as such there is no witness to give me a hint on how far to stand it of the back of the floor pan. Also my 2 parts cars are so buried in pack ice and snow that I may see them by July.
Any help would be greatly appreciated.
Thanx...Al
I am looking for some help on a dimesion for the lower tailgate on my Connie. What I need is a measurement on the lower tailgate rubber seal channel that is part of the rear floor pan. Top part of this channel has a rad in it and the bottom is flat. I need to replace the flat lower lip and I need to know how far it stands out. Does it come flush with the body or is it below that height?
Mine has been attacked by very severe rust and as such there is no witness to give me a hint on how far to stand it of the back of the floor pan. Also my 2 parts cars are so buried in pack ice and snow that I may see them by July.
Any help would be greatly appreciated.
Thanx...Al