Page 1 of 1

Question for Studebaker cars and or Conestoga folks

PostPosted: 2019 Apr 03 Wed 11:16 am
by Mike
Seems people stop by here, read and move on. Not much in the way of comments or questions any more.

So, I pose this this question - How many of you read the -
"Studebaker Drivers Site" ?
"Racing Studebaker's" ?
Or other Stude sites ?

Mike

Re: Question for Studebaker cars and or Conestoga folks

PostPosted: 2019 Apr 12 Fri 10:34 am
by BRIZ
Only here - only once in awhile.
Very rarely the SDC or the AOAI forums when looking for an answer when working on one of the studes - but I very rarely get my hand dirty. lol.
I wish we could have a designated Conestoga forum on the SDC forum where we might get a little more action and reduce some of my maintenance needs here.
Thanks for asking!

Re: Question for Studebaker cars and or Conestoga folks

PostPosted: 2019 Apr 12 Fri 12:52 pm
by Bert Cheney
I don't know mike. Maybe most people are too busy or too lazy. Bert

Re: Question for Studebaker cars and or Conestoga folks

PostPosted: 2019 Apr 12 Fri 1:24 pm
by Bert Cheney
Mike. I just found more old pages on the forum!!! Do you have any Stainless trim left from parts car? I need the long piece for the passenger side, that curves around to the tail gate that is just below the glass. I could also use both pieces of trim that are about half way up the door. Thanks, Bert

Re: Question for Studebaker cars and or Conestoga folks

PostPosted: 2019 Apr 13 Sat 11:04 am
by Mike
Hey Bert -

Wouldn't know it. I have the right (pass.) side, but I need it. Nothing on the left side of the 54 parts car.
I do have the 55 wagon that has most of the trim on it, but I need the whole car to go...not just a single piece of trim..!

Sorry I can't help.

Mike